Furnish and install mop receptor as manufactured by Florestone Products Co. Shoulder shall be not less than 4 in high inside and not less than 1-3/4 in wide. Galvanized, bonderized steel flange will extend at least one in above shoulder on one, two or three sides for installation against stud wall. Stainless steel protective cap to be cast integral on all four exposed sides. Drain body shall be brass, cast integral and shall provide for a non-caulked connection not less than one in deep to a 2 or 3 in pipe. Mop sinks with 3 in drains are supplied with a rubber seal for use on ABS, PVC or steel pipe. Receptor shall be manufactured of tan and white marble chips cast in white Portland cement to produce a compressive strength of not less than 3000 psi, seven days after casting. Terrazzo surface shall be ground and polished with all air holes and/or pits to be grouted and excess removed and sealed to resist stains and moisture. Receptor will be reinforced with 16 ga wire.

• Installation Sheet https://www.plumbers-supply-co.com//ASSETS/DOCUMENTS/ITEMS/EN/UNI-PS10152_Instal.pdf
• Specification Sheet https://www.plumbers-supply-co.com//ASSETS/DOCUMENTS/ITEMS/EN/UNI-PS10152_Spec.pdf
• Technical Drawing https://www.plumbers-supply-co.com//ASSETS/DOCUMENTS/ITEMS/EN/UNI-PS10152_Tech.pdf