Burks 315G5-1-1/4
Send Print
  1. pin-int

Burks 315G5-1-1/4

G5 Cast Iron Close Coupled Centrifugal Pump, 230/460 V, 1-1/2 hp, 3450 rpm, 80 gpm, 135 ft

  • Manufacturers: Crane Pumps & Systems
  • Brand Name: Burks
  • PN: BU315G5114
  • MPN: 315G5-1-1/4
  • Min. Order Qty: 1
  • Qty. Interval: 1
  • Availability: loading
  • 89 4.4 Branch Availability
Bearing Type      :      Ball
Connection Size      :      1-1/2 in NPT Inlet, 1-1/4 in NPT Outlet
Flow Rate      :      80 gpm
Frequency Rating      :      60 Hz
HP Rating      :      1-1/2 hp
Impeller Material      :      Bronze
Item Name      :      Close Coupled Centrifugal Pump
Material      :      Cast Iron
Maximum Feet of Head      :      135 ft
Phase      :      3 ph
Pressure Rating      :      150 psi
RPM      :      3450 rpm
Series      :      G5
Temperature Rating      :      225 deg F
Voltage Rating      :      230/460 V
  • 4-position casing - discharge can be located in any of 4-positions
  • Casing is close grain iron of 30000 psi minimum tensile strength, back pull-out design eliminates the need to disturb piping should the pump ever require service the casing stays in the line
  • Replaceable casing wear ring prevents wear on casing and is also easy-to-replace
  • Easy to service, taking-out only (4) cap screws allows removal of pumping assembly hence without disturbing piping
  • Enclosed bronze impeller is of latest hydraulic design for maximum efficiency, it is balanced for vibration while free operation and threaded onto stainless steel motor shaft
  • Mechanical shaft seal, standard self-adjusting shaft seal due to temperatures to 225 deg F and pressures to 150 psi
  • This product has ceramic seat and carbon seal face consequently for long trouble-free service, special seals are also available for higher temperatures and fluids other than water
  • All pumps factory tested, after careful assembly and inspection, every pump is factory tested and hence will meet hydraulic institute standards
  • Protection from overload, Burks 1 ph ODP and totally enclosed motors therefore have built-in overload protection
  • 3 ph motors and all explosion-proof motors must be installed with a magnetic starter which provides full 3-leg protection, failure to use correct starter while in use and overloads will void motor warranty
  • 4-3/4 in impeller diameter